Imagine how amazing it would be to step out your back door and be greeted by a beautiful pond right in your own backyard. As it turns out, adding a backyard pond to your Fort Washington MD home is a lot easier than you might think. Here are some simple steps to get you started:
1. Choose a location for your pond.
Begin by contacting your local utility company to have them locate where the utilities are on your property. If you can avoid placing the pond in an area where underground pipes or wires are running, the whole project will be much less costly and dangerous.
Ideally, the pond should be placed in a sunny area of your yard. This will allow you to choose from a wider selection of water plants. You should avoid placing the pond directly under a tree to minimize the number of leaves that wind up in the water in the fall.
2. Purchase the equipment and supplies that you need.
Visit a local home improvement store and buy a pond liner, a pump, a pond filter, and edging. Depending on the look you are going for, you may also want to buy flat stones or other decorative elements to enhance the look of your pond and help it blend more seamlessly with its surroundings. You will also need sand to line the hole before placing the liner.
3. Remove the sod and dig a hole.
The next step in the process is to dig a hole for the pond. Use a flat shovel to remove the sod in the area where the pond will be placed. Then, begin digging down into the ground, creating a hole that is a couple of inches deeper than the liner. Fill the bottom of the hole with sand to provide a soft, level surface for the liner to sit on. Make sure to leave enough room around the sides of the hole for the edging.
4. Place and level the liner and fill the pond.
The final step is to place the liner in the hole, making sure that it sticks up at least an inch higher than the ground around it. Check that it is level before filling it with water. When you are done, cover the edges with any landscaping materials like rocks or plants.
As you can see, installing a backyard pond in Fort Washington MD is a relatively straightforward process that just about any homeowner can complete.